York Fitness Active 120 Manuel du propriétaire télécharger pdf (Page 12)

www.yorkfitness.com

Troubleshooting

If you have a problem with your treadmill, before you do anything else please check that

all the cables have been connected correctly. Loose cables are very common and many

problems can be solved by making sure the cables are properly connected.

The following table details the most common problems and how to fix them. If you still have a problem after going

through the troubleshooting guide please call your local YORK distributor for advice.

PROBLEM CAUSE CORRECTION

TREADMILL WILL NOT START

Not plugged in. Plug into suitable outlet.

Safety key not attached correctly. Insert safety key.

Treadmill circuit breaker tripped. Reset circuit breaker.

On/Off switch not turned on. On/Off switch turn on.

Auto shut down time out. Unplug and re-plug electrical cord.

TREADMILL BELT SLIPPING

Walking belt too loose. Tighten walking belt.

Deck needs lubrication. Lubricate belt and deck.

TREADMILL NOISY

Loose hardware. Tighten all visible screws, nut, and bolts.

Motor straining. Check mat tension - 3 finger test.

Clicking sound - roller knocking. Adjust rear rollers - check the tension.

INACCURATE PULSE RATE

Too much hand movement.

Stand on side rails to get accurate pulse

reading.

Palms too wet. Dry palms.

Gripping hand grips too tight. Grip using moderate pressure.

Wearing rings. Remove all rings.

Console Troubleshooting Guide

The console will display information regarding operational faults with the treadmill. If your treadmill behaves in an

unusual way and seems to have developed a fault, turn it off at the electrical outlet and then back on again. This

should clear the treadmill of incidental error and prepare it for normal operation. If there is still a problem call your

local York distributor for advice. Please find below some specific error messages you may see on the display:

ERROR CODE PROGRAM DESCRIPTION

E01

Wiring set connection not good

Monitor not good

Transformer not good

Control board not good

E02

Motor wire and motor not good

Wire between the motor and control board not good

E03

Speed sensor fit not well

Speed sensor not good

Connection between the speed and control board not good

E05

Control board not good

Motor not good

In all cases turn the treadmill off at the electrical outlet and then back on again. If this does not work, call your local

York distributor for advice. In the event of an electrical failure treadmill will automatically shut off. To restart:

1. Unplugthepowercablefromthetreadmill

2. Pushinthesafetyswitch

3. Re-plugthepowercableintothetreadmill

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

York Fitness Active 120 Manuel du propriétaire Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Tapis de course York Fitness Active 120